What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 24.06.2025 11:01

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
But… the neutral is now “floating” because of the 1 ohm resistance.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
but this device (an Inductor) … impedes the rapid changes in the current.
The bolt then partially travels down the line to your home.
nine
How likely do TWS earbuds explode these days? I'm still using wired earbud because I'm paranoid.
The third is lightning and “how it gets conducted into a home.”
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
a photo is worth a thousand words.
A circuit breaker is similar, but is resettable.
Because the load is inductive, the current lags the voltage.(by a bit).
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
If You Have an Asus Router, You Need to Check If It's Been Hacked - Lifehacker
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
But it can get overloaded, and no longer works.
First Sentence:
Making a Diving Catch For Space - NASA Watch
What is lightning?
These are simplified answers to the original question, and does not change anything I wrote above.
but I think this circuit , shows a few more pieces.
Has the current political environment caused Canadians to cancel trips to the United States?
Now when you have a certain ac resistance, then a current flows in a loop.
He then describes Rainy Season and Lightning.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
If sea levels were rising, wouldn't the acreage of coastal salt marshes increase? Are they?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
One is “what exactly is in a ‘surge protector’ ? ”
007 First Light Trailer Reveals The First-Ever James Bond Origin Story - GameSpot
This is where this question deviates from being a 'generic' question, and becomes more specific.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
2024–10–14 [Omar Gharbi Omar Gharbi ]
This device then solves the entire problem.
At least they know the answer if they wanted it.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
One
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is where the MOV conducts again, and dissipated the energy.
The other is “what does a “fuse” do?”
Edit 2024–10.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Here is a simplified AC power diagram.
Upvotes:
What does a fuse do?
There are two important concepts here.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This is 'the assistant's answer'
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
2024–10–10[John johnson John Johnson ]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
(Dc diagram shown, AC is similar).
So, the voltage could go up to 500 volts, and the fuse will not open up.
so, what happens?
He then describes the function of a fuse.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
[old diagram got deleted by accident]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
The MOV will conduct when the voltage exceeds 50% of line voltage.
This one hit behind the barn.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
[image of Common-mode choke]
2024–10–16 [ OO OLAOYE OYEBODE ]
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
the problem then depends on "how fast does the fuse operate?".
Barnstars:
It seems Mohan does not understand the difference between a comment and an Answer.
In schematic diagrams this is the symbol for a fuse:
I post the exact comment here.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
At one ohm, the resistor has a maximum of 1 watt power.
For this case there are devices called Metal oxide varistors (MOV).
It also is a device that limits the change in current flow.
A fuse is a non-resetable over current circuit protector.
He then asserts :
These devices are installed between the “hot” and “neutral” and protective ground.
eight
There are three different concepts here that are getting confused.
what exactly is a ‘surge’ protector?
An AC voltage/ current source, and an ac inductive load.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is the picture of an electronic coil of wire wound around a core of magnetic material.